Hi guys,
I have an issue with a HPE 1920S switch and the remote management. The scenario is the following: in customer network management VLAN is 200, and right now I can access the switch locally connecting my laptop to the switch port 22, which is an untagged member of VLAN 200. But I want to have remote access to the switch through ports 23 and 24, which I configured as tagged members of VLAN 200 and go to the uplink switch. In the "Get Connected" page I set Management VLAN ID to 200 and Management Port to None, because I want access the switch through port 22, 23 or 24. According to the configuration guide page 21: "If no management port is specified, then all ports that are members of the management VLAN provide access to the switch management interface."
However, after these configurations I have no remote access to the switch, but I can ping gateway 172.30.0.1 from the switch, which is in customer network beyond the uplink switch, so I can be sure VLAN 200 is passing through ports 23 and 24. What could be wrong? Am I missing anything? Attached the topology. Many thanks in advance.
Regards,
Julián