Hello Guys,
I have got a HP V1910-48G JE009A on my desk without any credentials.
This switch needs te be set to factory defaults.
Steps I took so far;
- Connect switch cable to COM
- Open Putty on COM 38400 – 8 – 1 – N
- Powercycle the switch
- Press Ctrl-B at boot to enter extended boot menu
- 7. Skip current system configuration
- 0. Reboot
After reboot I did the following:
- Press Ctrl-B at boot to enter extended boot menu
- 5. Restore to factory default configuration
Switch here tells me:
Password recovery capability is enabled. To perform this operation, first disable the password recovery capability using the undo password-recovery enable command in CLI.
How should I go about this? Can I access CLI without any login credentials?
Any help or advice is appriciated.
Regards, René.